USB to DMX

Drivers installation for your USB to DMX interface

You can watch my video guide on youtube or follow the steps underneath the video link.
https://youtu.be/AtaGOYqUTkY

Link to the FTDI website:

https://www.ftdichip.com/Drivers/D2XX.htm

On the FTDI website Scroll down to the tab with releases for various platforms.

As this is the guide for installing the drivers on windows click on the setup executable as you see on picture below

The setup will start downloading automatically.Once finished downloading go to place where the file has been downloaded. In most of the browsers it will be in Downloads.

Once you located the file you will have to unzip it. Just right click on the file and select Extract All.

Extracting wizard will open. Please tick "Show Extracted Files..." and all click Extract.

New tab will open with your fully extracted setup file.

Right click on the setup file and select "Run as Administrator"

Msg will pop up to allow this program to make changes to this computer. Just click yes. Then follow the installation wizard click " Extract "

Then click " Next "

Now you will have to click on " i accept the agreement " and click " Next"

Finally click Finish. All done drivers are installed.

You can plug your USB to DMX interface and windows will automatically assign the newly installed driver to your device. If you wish you can check in " Device Manager "

Now you can use your favourite DMX software with your USB to DMX interface.

I would recommend for you to check my guide on how to set your device in Freestyler even if you planning on using different software most steps are very similar.

For the guide please click below.